Donald Lee Smith's Magnetic Generator

An overview of generators by Don Smith

Donald Lee Smith's generator works on a collapsing dielectric field that produces transient voltages in an electrical circuit. The voltage generated has a very high value, and it is harnessed to generate free energy. Normally, the voltage generated by the tension of the Ether of the circuit has a back electromagnetic field (Back EMF). However, Don Smith applied the method that Tesla did in the Ether field to remove the Back EMF. Specifically, using the spark gap to release the Back EMF, or using a Bifilar coil, or incorporating more permanent magnets.

Don Smith's Generator is a static free energy generator that uses power segmentation into several stages, producing voltage transients that occur many times over a short period of time. That is quite similar to the Tesla coil (Tesla transformer). And indeed, the various versions of Don Smith all have the essence of Tesla technology in them, including one that looks a lot like a Tesla coil.

Don Smith generator improved from Tesla technology - Tesla Transformer

In general, the free energy produced by Don Smith is in the form of Radiant Energy. Converting it to a pure DC voltage through a bridge diode rectifier, or using an electronic circuit consisting of an L-C oscillator circuit (coil and capacitor) to generate a typical AC current of 50 - 60Hz.

Note:

• With generators using Bifilar coils, the magnetism at the coils of the Don Smith generator still exists, even after the Back EMF is removed. Magnetism is established by a Bifilar coil with an electromagnetic field in the form of a standing wave. This is the main difference compared to other generators. For the non-Bifilar version, Don Smith uses the resonance method and removes the Back EMF through the spark gap.
• The "Magnetic" in Don Smith's generator is considered an object that generates voltage and is a parameter for resonance. That is according to the research of today's academic community. According to Nikola Tesla's theory, Don Smith's magnetic dynamo is exactly the generator that generates radiant energy from an electronic circuit.

Circuit diagram of generator Don Smith

Don Smith has many different versions for free energy generators. All versions share the same essence of harnessing the tension of the Ether from the collapsing dielectric field to generate free energy.

Introducing 2 models of Don Smith generators:

1/ Use Bifilar coil

Primary and secondary coils are placed on a rod core. All of the coils are arranged in special manner. The primary and secondary windings are wound on a core in the form of a shaft, called Rod Core as shown below.

The secondary winding is wound in a Bifilar coil style with a tubular (not pancake) version. The versions of the Bifilar coil are presented here: Bifilar Coil

All of the coils are wound in the same direction.

Explanation:

The electromagnetic fields produced by the resonant (excitation) current and the load current are perpendicular to each other: 

So, although you have power in the load, resonance is not destroyed by that output power.

Comments: The load must be chosen so as to get the maximum amount of power flowing into it. Very low loads and very high loads will both have close to zero energy flowing in them.

The secondary coil is shunting the primary coil, and so it has a current flowing in it even if no loads are connected.

The secondary coil can be adjusted for resonance too.

The “rod” material can be air, or other materials. 

IT IS IMPOSSIBLE! Without back EMF suppression By Don Smith:

Multi-coil system for energy multiplication

Related: Back EMF Exploitation Due To Circuit Breaker of Reed Switch

2/ Variation of Tesla Coil

The Tesla coil is where the Ether tension is established, which then causes the dielectric field to collapse, manifesting as a rapidly collapsing magnetic field close to the speed of light. And moreover, the transient voltage after each collapse increases many times due to the Ether stress. This high voltage is generated many times in a short time. And that is the high frequency and high voltage characteristics of the Tesla coil.

Of course, the Tesla coil has Overunity (the output is greater than the input), and Don Smith has harnessed that power. Here is the circuit diagram:

A generator by Don Smith according to the Tesla coil variant (Tesla transformer)

Both of the two out of phase outputs were used and both connected to the step-down transformer.

1. Between sparks:

There is no current in the step-down transformer and so the two ends of L2 are at the same voltage.

2. During a spark:

Parasitic capacitors (not shown) connected across both sections of L2 are discharged to ground, and current is produced in the step-down transformer. One end of L2 is at ground potential. But, the magnetic field of this current in L2 is perpendicular to the resonating field and so has no influence on it. As a result of this, you have power in the load, but the resonance is not destroyed.

COMMENTS: In my opinion, these schematics have errors in the excitation section. Find those errors. Excitation by a single spark is possible.

In the terminology of Mr. Tesla, this is a ‘charge pump’ or ‘charge funnel’. The charges are coming from the Ground which is the source of the energy. There are more secrets in the following parts. 

Make a Don Smith Generator

Prepare knowledge: It is important that you understand the knowledge of capacitors, theory of electromagnetic fields, etc. But electrical science in physics today is only half the story of electricity. The complete theory of electricity is the Ether field theory. You can start with Eric Dollard's book - A Common Language for Electrical Engineering: Lone Pine Writings

Understand circuit diagrams: You can understand according to common electrical theory. But "Back EMF" is actually a returning electromagnetic field, not a returning electromotive force. Learn more: Harness the power of Back EMF for Free Energy

You don't necessarily need to relearn Ether physics theory, because the knowledge is vast. So you can refer to some articles on electrical theory at Blog Overunity is enough.

Then buy electronic components according to the circuit diagram of Don Smith to build a generator yourself.

Revealed At Last... Must watch!
Free Energy Magnetic Generator and synthesizes many other technologies imbued with Nikola Tesla's technological identity

✔ Nikola Tesla’s method of magnifying electric power by neutralizing the magnetic counter-forces in an electric generator

Generates Energy-On-Demand: 👉 Free Energy Will Change Our World Forever

✔ Combination of induction motor and alternator 
✔ Combine generators with induction motors - self-powered generators with rotary motion
✔ Various methods of generating high power immobile generators
✔ Or maybe called Overunity for the system. Mother Nature doesn't care about people calling or naming phenomena. Overunity/Free Energy, Zero Point Energy (ZPE) are just a few different words

Introducing Some Circuit Diagram for Back EMF Mining to generate Overunity - Free Energy:

Don Smith's Magnetic Generator has many other versions. But in general, the versions carry the identity of Tesla's technology, including turning the harmful Back EMF into a beneficial EMF for the generator. And in particular, Don Smith's generator is exactly a generator of radiant energy extracted from electronic circuits, including establishing electronic circuit connections and "proper" grounding. So, as mentioned above, Don Smith's magnetic generator is considered a generator that harnesses power from the ground!

So if you are really interested in Nikola Tesla's genuine radiant energy (not solar energy), I suggest 2 topics for you to study more:

• Radiant energy according to the version of the Tesla coil, with the standard grounded electronic circuit: 👉 Free Energy From Tesla Coil - Tesla Transformer Become Generator!
• Moray's radiant energy: 👉 Today's Science Talks About Moray's Radiant Energy
• Instructions for creating a radiant energy generator from an electronic circuit: 👉 Radiant Energy with Bifilar coil - Impulse Technology

The above links will be suitable for those who want to develop their knowledge of Electronics and make a Radiant Energy Generator from electronic components.