Alfred M. Hubbard's Free Energy Transformer Building Guides

Overunity Electricity will guide you through building Alfred M. HUBBARD's Free Energy Transformer. This is technology that was once suppressed, and is considered a lost invention.

Tracing Alfred Hubbard's Generator blueprints

Alfred Hubbard's free energy generator is recorded by newspapers, reports of electrical engineers. Technical drawings of the Alfred Hubbard generator are not made public.

The Seattle newspaper witnessed and reported Hubbard's generator in 1956:

The Hubbard Energy Transformer

by Gaston Burridge

Fate Magazine, July, 1956, pp. 36-42

One of the interesting experiments made with the Hubbard transformer was the propelling of an 18 foot boat around the Portage Bay near Seattle.

A 35 horse power electric motor was hooked up to a Hubbard transformer measuring maybe 12 14 inches in diameter and 14 inches in length. It furnished enough energy to drive the boat and a pilot at a good clip around the bay.

The demonstration lasted several hours and created a sensation. The test required enough current for a long enough time to rule out any sort of battery, being housed in the device.

The voltage could be … 220 volts. It seems unlikely a 35 horsepower motor would have as a low voltage of 110 volts.

Soon after the demonstration, Hubbard's name dropped from the Seattle paper and he went to work for the Radium Chemical Company of Pittsburgh — now of New York. 

Since then, no one knows the blueprints of Hubbard's invention. These generator data are sought after by energy experts, whose blueprint data are available in leaked, incomplete form.

It is because of the leaked data that there are many inventions that are quite similar to the Hubbard generator described. Inventions similar to Hubbard's invention:

• Self-Sustaining Electrical Generator by William BARBAT
• Self-Powered Transformer - Free Energy Generator of André Coutier

In July 1973 a former resident of Seattle then living in Houston, Texas, wrote to the Post Intelligencer to inquire whether it had published any additional data on Hubbard since the appearance of the articles in the 1920s. In answer to this query, Don Carter, a staff reporter, wrote a follow-up story, dated 16 July 1973 and headlined

“Saga of a Boy Inventor and His Mystery Motor.”

Carter hints that the Hubbard invention was remanded to oblivion by officialdom.

Some clues about Hubbard's invention in the newspapers:

A local capitalist agreed to witness a demonstration of the coil to determine its practicability as a power source. The motorboat was fitted with blocks on which to rest the motor and the propeller shaft geared for a chained belt. When the motor was first tried out after its installation in the boat it ran backwards. So involved are the connections between the motor and the coil that fully a half-hour’s experimentation was necessary before the motor shaft revolved in the right direction.

The Post-Intelligencer (Seattle WA), Thursday, July 29, 1920. Alfred M. Hubbard, Seattle boy inventor of a device which for want of a better name he terms an “atmospheric power generator,” yesterday made good his prediction that he would drive a motorboat with his apparatus as the source of power. 

While the device has been patented, the claims for it are so broad that Hubbard says he does not feel safe in making public his secret. In general, he says, it is made up of a group of eight electro-magnets, each with primary and secondary windings of copper wire, which are arranged around a large steel core. The core likewise has a single winding. A coil thus constructed, he says, is lifeless until given an initial impulse. This is done by connecting the ends of its windings for a fraction of a second to an ordinary [two words unreadable R.L.R.] -ing circuit, he says.

Alfred M. Hubbard, Seattle, ca. 1924

In 1919 Hubbard represented the apparatus as being capable of extracting electrical energy directly from the air, but he admitted yesterday that this had been merely a subterfuge to protect his patent rights, and that, as a matter of fact, it had been a device for extracting electrical energy from radium, by means of a series of transformers which stepped up the rays... He declined to go into detail in regard to the exact manner in which he managed to extract power from radium -- but said that, so far as he had been able to determine, there was no great difference between the Detroit machine and his.

Finding what was lost: Hubbard's invention of the Free Power Transformer - an oppressed technology

Alfred M. Hubbard's free power transformer information includes:

• Information leaked by experts, journalists, legends
• Hubbard's Generator-Like Inventions
• Information from newspapers, confidential documents

Note: When the Seattle Post-Intelligencer published the same story, Hubbard, suspecting that his own invention might have been purloined by Hendershot, complained to a staff reporter, R. B . Bermann, who three days later wrote an article headlined “Hubbard Believes Mystery Motor Based upon His Own Invention.”

Technical drawing for Alfred M. Hubbard's free power transformer invention created by experts:

Technical drawing in the form of a block diagram, not specifying how to wind the coil

The input has two wires. This is true of many of Hubbard's generators and generator images. But, the difficulty here is that the diagram does not explain why the output of the free energy transformer has 4 terminals (outputs).

Alfred M. Hubbard's Free Energy Transformer with 4 outputs

Because William BARBAT's generator is similar to Hubbard's generator, with the secondary winding being wound in the style of Nikola Tesla's Bifilar winding. The Bifilar coil has many versions, in addition to the original version, it is also known as Tesla's folding coil.

Tesla's folding coil

Connect the 8 secondary windings of the transformer according to the Bifilar winding pattern:

Overunity Electricity Blog "Decoding" of the secondary winding at Hubbard's free energy transformer.

Notes on the image above:

There are 8 secondary windings, each coiled by 2 single wires, with 4 ends for each coil. Wind the 8 coils in a Bifilar coil style, and as a result we still have 4 outputs, and the 2 ends will be reconnected or opened as a switch.

Points 1, 2, 3, 4 are generator outputs

• 1 and 3 will be connected together like a switch
• 2 and 4 will be the place for the output voltage

The way the primary winding is wound is also according to the Bifilar winding style, but there is only one electrical conductor, two ends of the wire:

Hubbard's primary winding is wound in a Bifilar coil pattern

And here is the result of winding the wire around the iron core to make a Hubbard transformer at a preliminary level:

Compare the image above with that of the incompletely revealed Alfred Hubbard generator:

Leak: Alfred Hubbard generator incompletely revealed

Alfred Hubbard generator built with wooden box:

Preliminary design for Alfred Hubbard generator, no control board, no voltage for primary winding

All of the above is the "soul" of Alfred Hubbard's free power transformer. The job now is to push - urge - to make it work by the input voltage.

Voltage applied to the primary winding of Alfred Hubbard's free-energy transformer

According to Alfred Hubbard, the voltage supplied to the primary winding must be a square DC pulse, with the lowest voltage of the pulse slightly higher than 0V.

DC Pulse

The way to get the above signal is to design an electronic circuit that generates a square pulse, consisting of connected electronic components. Another quick alternative is to use a DC Square Pulse Generator.

See details of this device: PWM Pulse Square Wave Signal Generator Full Function APWM Rectangular Wave Frequency Duty Cycle Adjustable DC 3.5-12V for MCU

With the above device, its supply voltage is DC 3.5~12V, which means you can use a regular 12V battery or phone charger to power it. And just charge your phone, you can "free electricity" for the whole house.

With the above device, that is enough to generate the required square pulse, with the lowest threshold voltage greater than 0V. But to control the width, amplitude, lowest voltage threshold of the square pulse, manifold frequency modulation, etc., you should use equipment intended for research:

• Basic electronic circuit, generating only square pulses
• NE555 Pulse Frequency Duty Cycle Adjustable Module Square Wave 5V-12V Signal Generator For Arduino Smart Car
• 1HZ~150KHZ Signal Generator Digital Display PWM Pulse Frequency Duty Ratio Adjustable Square Wave Rectangular Signal Generator

 Revealed At Last: Ancient Invention Generates Energy-On-Demand

✔ Nikola Tesla’s method of magnifying electric power by neutralizing the magnetic counter-forces in an electric generator

Generates Energy-On-Demand: Easy Power Plan Will Change Our World Forever

✔ Combination of induction motor and alternator 
✔ Combine generators with induction motors - self-powered generators with rotary motion
✔ Various methods of generating high power immobile generators
✔ Or maybe called Overunity for the system. Mother Nature doesn't care about people calling or naming phenomena. Overunity or Free Energy, or Zero Point Energy (ZPE) are just a few different words

Side problems in building Hubbard generators

Above, I have guided you through the two most important problems of Hubbard generators, which are the design of the primary and secondary windings, and the voltage supplied to the primary winding.

Once done, you need to measure the output frequency and voltage, and the current. If the output voltage is too large, adjust at the DC pulse generator so that the DC voltage is low. And if you want to have a frequency of 50 -60Hz, let the square pulse generator have that frequency as well.

In addition, there are a few things you should keep in mind:

• Electrical safety, avoid electric shock
• The coil is made of copper material,
• transformer core made of iron
• It is recommended to make a case for the transformer for safety

Buy a voltage and current meter:

• UNI-T UT210E Pro UNIT Mini Digital AC DC Current Clamp Meter Voltage Voltmeter 100A Ammeter Electrical Frequency Tester
• All voltage and current meter

If you have trouble building Hubbard generator, you can message me at social network:

Facebook: Overunity Electricity

Reddit: Free Energy Transformer (Ask an issue by leaving a comment)

Good luck!

Finally, in terms of the science behind Hubbard's generator, you can't explain how it works with what's been learned in the schools of mainstream science. To fully explain the free energy phenomenon at Hubbard's transformer, we need the scientific theory of Ether. Engineers and developers still use Ether physics for their careers, but these are just a few. You can find them, engineers, researchers in the Ether field at energy forums. See more about free power transformers and Ether: Floyd Sweet's Ether Field Transformer

Note: 

1/ Tesla also alluded to the fact that his ultra sensitive receiver could be modified to pick-up, store, and amplify the natural vibrations, [electricity], constantly going on in the upper reaches of the earth’s gaseous envelope. [It] would work night and day and in any weather. Containing not a single moving part, it would have the unnerving appearance of just “sitting there” and putting out electricity.

Writing on 10 June 1902 to his friend Robert U. Johnson, editor of Century Magazine, Tesla included a clipping from the previous day’s New York Herald about one Clemente Figueras, a woods and forests engineer in Las Palmas, capital of the Canary Islands, who had invented a device for generating electricity without burning fuel.

Figueras’s subsequent history is not known, but his achievement prompted Tesla, in his letter to Johnson, to claim priority for first having developed a device similar to the one produced at Las Palmas and, especially, for having revealed the physical laws underlying it.

2/ In 1920, at the age of 19, Alfred Hubbard built a coil and motor that ran his boat 10 knots an hour on Portage Bay in Seattle on July 29th. He called this ‘fuelless’ unit an ‘atmospheric power generator.’ Hubbard claimed it could operate for years; drive a large car; light an office building; and fly a plane around the world nonstop. Little is known about the Hubbard Coil. “Since Alfred Hubbard worked with Tesla for a short period, it seems likely that his transformer is based on [information from] Tesla.” [Especially since Hubbard failed to build his generator to match the load he put on it in his public boating demo and Tesla is still the only one known “for having revealed the physical laws underlying it.”]

3/ Learn more about Ether and magnetism:

• ۞ Uncovering the Missing Secrets of Magnetism
• ۞ Zero Point Energy Generator
• ۞ Electricity Invented

4/ For the sake of simplicity, above, I have not set the transformer to self-powered. If self-powered mode is active, then after starting, it does not need external power supply. However, with just one battery, or a phone charger, you will keep the transformer working for a long time, for a very small cost.